Moparts Tech Archive

Automatic Trans.

Trans swaps, & Mounts & Brackets ?'s

Fish67
Moparts Member
Posts: 2343
From: Columbus, OH
Registered: Jun 2001
posted 06-02-2002 07:17 PM

I switched from a 904 to a 727. the tailshaft brackets for the 904 don't look like they'll work.
Are they different for the 727?
============================================\

John Russo
Moparts Member
Posts: 1837
From: Portsmouth, VA, USA
Registered: Nov 1999
posted 06-02-2002 10:53 PM

The holes in the tailhousing are in the same place for the trans mount for both trannies. Should be a bolt in swap. What kind of problem does it look like? John
============================================

info provided by members listed above

I have two brackets left over

Fish67
Moparts Member
Posts: 2343
From: Columbus, OH
Registered: Jun 2001
posted 06-02-2002 10:57 PM

I have two brackets left over.....Might be engine to trany brackets? They were on the 904 removed 10 years ago and I can't find them in the service or parts manuals. I am sure they need to go on there. *sigh*
The brackets are about 8 to 10 inches long and have a hole at either end.
============================================

RustyBlue
Moparts Member
Posts: 270
From: Roswell, GA USA
Registered: Aug 2001
posted 06-02-2002 10:59 PM

Those are engine to bell housing brackets and you can survive without them.
==========================================

Dennis
Moparts Member
Posts: 6820
From: Eagle Creek, OR U.S.A.
Registered: Nov 1999
posted 06-02-2002 11:01 PM

That sounds like the brackets that run from the holes in the lower sides of the block, down to the 2 7/16" bolt holes at the bottom of the bellhousing. They are different between 727 and 904. Dennis
============================================

info provided by members listed above

Tech Index